I have an old plywood mirror dinghy which has developed some rot around the top of the bow section. The block with the painter and forestay eyes is ok but the wood around this is spongy. What would people recommend? Replace entire bow section (£40 from trident) or patch repair? The materials needed for a repair look as expensive but removing the whole bow for a relatively small affected area seems excessive!
PuffinInTegel
Fri, 08/11/2017 - 22:42
Permalink
Replace a section
Hello and welcome!
If the ply is spongy, there is a risk that the solid blocks inside and outside may be rotten inside as well, although they look solid on the exterior (because they're usually soaked with epoxy on the surface). I learned that the hard way when my port shroud simply pulled out of the block and my mast went overboard in a light breeze. You could try a temporary fix (some additional ply on either side of the blocks) to take you to the end of the season. For a permanent repair, I'd cut away all soft ply and replace it, re-using your block if that's still completely solid. There are quite a lot of "patching" discussions here. I prefer cutting away the plies in matching steps but most members seem to favour a slanted scarf.
Very few have reported replacing entire panels such as the bow transom etc.
Hope you are successful, whatever course you take.
Gernot H.