Mirror 64770 repair advice

Hi
I'm hoping someone might be able to help with some advice about how to repair 64770. My dad built this boat with a little help from me and my brother (we were 13 and 12 at the time) and it was launched in 1981.
At some point it went to live with my uncle who must have had it for 20 years and now it has come back to me.
I didn't think the condition was too bad but here are the results of some scraping of loose paint and varnish:
There's a soft spot in the floor but not too bad and probably just needs reinforcing with glass on the inside.
Elsewhere below the waterline seems fine.
We'd spotted that the gunwhales had some soft spots and it turns out that a few patches above the waterline were rotten.
The results of removing both inner and outer gunwhales and pulling out the soft wood by hand can bee seen here http://s1308.photobucket.com/user/praven68/library/Mirror%2064770

Can anyone suggest the best way to go about repairing those panels?

Cheers
Paul

62816inBerlin's picture

Welcome, Paul!
The first step is definitely establishing the extent of the rot, then cutting it back to healthy wood.
After that, there are three ways to go.
a) Simplest method is to make patches and butt-join them or even overlap (if you don't mind the edges) them onto the healthy wood with fibreglass tape on one or both sides. Kelly (see http://forum.mirrordiscussforum.org/node/368) used the butt-joint method and then glassed over the hull. There is a video of his project at https://www.youtube.com/watch?v=xQ7YqCaa470 where the work in progress is shown.
b) More difficult than a) but potentially stronger and more frequently used is scarfing at an angle, i.e. bevelling the edges of the hole and the patch to match one another. This is shown in a video by another Forumite at https://www.youtube.com/watch?v=-JcAB1-RzCY .
Forumite Smilicus from South Africa posted some pictures of his restoration using this method in http://forum.mirrordiscussforum.org/node/257 .
c) A variant of scarfing is to remove layers of plywood so that they match, in steps. I used this on my boat (with difficulty, as I could not get matching plywood). My short description is in http://www.hirsinger-translations.de/gast/boating/patch.pdf . The document is old and the pictures date back to the pre-digital days, I'm afraid, but should give you an idea of what's meant.
If you've lots of time, follow the thread below, discussing the rebirht of a Mirror that was virtually dead!
Duncan Gibbs used mostly the method a) butt-joints.
http://forum.woodenboat.com/showthread.php?79026-An-update-on-The-Mighty...

Wishing you success in the restoration!
Gernot H.

Hi Gernot
Thank you very much for gathering together those different methods. I will discuss with my friend who is going to help me and we will decide which method to use.
I will return with an update on progress.
Cheers
Paul

Hi
Well we got the boat repaired and its first sail was a Wednesday evening race in July on the Exe.
Photos of the restoration process here: https://www.dropbox.com/sh/c72vhgm1l17s3ma/AABidOSwGYnUtDyNcT9KA6xra?dl=0

Thanks for the advice.

Absolutely amazing. I would call it a rebirth. Thanks for sharing.

Pete

curlew's picture

I have treated wet rotting wood with Blue Car Antifreeze to kill spores. Soak for 48 hours until dry. Keep cats away.
david