Hello,
I have just brought a grp Mirror and have the recommended rowlocks and sockets for grp Mirrors (as supplied by Trident) - the previous owner sited them incorrectly so I will move them back. My question is, what is the best way of reinforcing the gunwale to take the strain, and should the reinforcement extend to the surrounding topsides/hull?
Any advice, pictures etc gratefully received,
Ellie
PuffinInTegel
Fri, 05/05/2017 - 14:26
Permalink
Reinforcement
Hello and welcome a-online!
Being a wooden-boat-owner I'm not sure about the strength of the gunwales and hull of GRP boats, but if in doubt, back the hull internally with a piece of plywood before gluing/screwing on the rowlock blocks.
I hope some of our members (users beermatt and Alan ? ) who have GRP boats can be of more help.
Cheers,
Gernot H.
Ellie
Mon, 05/08/2017 - 13:41
Permalink
Reinforcement
Thanks, Gernot,
that sounds a robust solution!
Kind REgards,
Ellie
beermatt
Fri, 05/19/2017 - 22:08
Permalink
Depends how hard you row
Hi Ellie
Sorry I'm late to the party, haven't been on a while.
If you scroll right down to the bottom of this post http://forum.mirrordiscussforum.org/node/293 (or here http://imgur.com/a/1RpRM#UyvRQRT ) I put a picture up of my reinforced oarlocks on my GRP Mirror.
Cut and tapered a block of wood thick enough to completely fill the gap inbetween the outer and inner walls of the gunwale*, epoxied in and then bolted 4 times. In addition a steel plate that came with the rowlocks screwed in to the top.
(*for anyone who hasn't seen both, the gunwales are solid wood on wooden Mirrors but hollow and open at the bottom on GRPs)
This might be overkill but I row hard and have broken 3 Mirror dinghy oarlocks in the past so was determined it wasn't going to happen again!
Cheers
Matt
Ellie
Wed, 05/31/2017 - 13:38
Permalink
Rowlocks
Matt,
Thanks for that - seems like an excellent solution and starting work on the boat next weekend. As I will sometimes be rowing against the tide, I like the reinforced idea!
Thanks again,
Ellie