Can anyone describe how the cockpit floor battens are fixed to the hull plywood? And are they supposed to line up with the external rubbing strakes below?
My ply floor has quite a bit of flex in it, so I am thinking of inserting four floor battens instead of just two, then screwing through to a similar piece underneath', but I need to remove the existing wooden bits without causing too much damage first of all. Any suggestions welcome. BTW I saw "Pippin's" new reinforcing hull piece epoxied into the cockpit centre line on the wooden boat forum. That's one method. Thanks, Jim.
62816inBerlin
Fri, 07/19/2013 - 15:43
Permalink
Battens
Seeing the strength of modern epoxy resins, I wouldn't bother to screw or bolt anything through the hull, but sand the inside down to the epoxy layer that ought to be on the plywood, then glue the new battens in by putting weights on them. A bit of pre-bending (steaming or wet-bending and then allowing to dry in bent condition) helps to distribute forces better.
Cheers,
Gernot H.